NEC Univerge SV9300, Networking Manual, Page: 311 / 364

Chapter 2 Q-SIG FEATURES
2-35
NWA-088654-001 Rev.1.0
94ch2001.fm
OVERLAP RECEIVING-Q-SIG
In addition to the programming for Overlap Receiving-Q-SIG, do the following data programming.
[Russia Only]
DESCRIPTION DATA
Specify whether Dial Tone (DT) is sent to call-
ing party of opposite office when receiving the
SETUP message by Overlap Receiving-Q-
SIG.
NOTE 1: This command can be also used to
specify whether “the SETUP mes-
sage does not contain a called party
number” is enabled or not. When
“the SETUP message does not con-
tain a called party number mes-
sage” is not enabled, assign the
second data to “0”.
NOTE 2:
This command should be assigned
to incoming trunk route when send-
ing DT to calling party.
NOTE 3:
This command should be assigned
to both incoming trunk route and
outgoing trunk when “the message
does not contain a called party num-
ber” is not enabled.
•
(1)
(2)
Y=244
00-63: Trunk Route
0 : To send DT of own office
1 : Not sent
Assign Progress Description by Overlap Re-
ceiving-Q-SIG.
NOTE 1: This command is effective when the
second data of CM35 Y=244 is as-
signed to “0”.
NOTE 2: This command should be assigned
to incoming trunk route.
•
(1)
(2)
Y=272
00-63: Trunk Route
1-4, 8: Progress Description
15
: No data
START
CM35
A