![background image](http://html.mh-extra.com/html/nec/univerge-sv9300/univerge-sv9300_networking-manual_249030012.webp)
INTRODUCTION
6
NWA-088654-001 Rev.1.0
94ch0001.fm
HOW TO READ THIS MANUAL
HOW TO READ THIS MANUAL
Chapter 1 through Chapter 3 explains the feature programming for each service about the following items.
PROGRAMMING
This section explains the programming procedure for each service.
The meanings of (1), (2) and marking are as follows.
(1)
:
1st data
(2)
:
2nd data
: Default; With the system data clear command (CM00, CM01), the data with this marking is
automatically set for each command.
: A reset of the CPU blade is required after data setting.
Press RESET switch on the CPU blade.
: Command with this marking can be used only under Off-Line mode of the CPU
blade. To set Off-Line mode,
(1) Set SENSE switch on the CPU blade to “E” or “F”.
(2) Press RESET switch on the CPU blade.
: Commands which require a reset of the blade by CME0 Y=3 after data setting.
RESET
OFF LINE
BLADE RESET