NEC UNIVERGE DT700, User Manual

Page: 58 / 382

I N T R O D U C T I O N T O T H E D T 7 0 0 A N D D T 7 3 0 G P H O N E S
Optional Equipment
2-40
DT700 Phone User Guide
Speed Dial keys can be configure on the DCL-60 Console to allow the phone to
monitor the status or presence of other users.
Note:
Only one connection to the Side 2 connector port is available on the phone, so
the phone can only support a DCL-60 console OR a Jabra headset. Both
cannot be connected to the same phone at the same time.
M A X I M U M N U M B E R O F L I N E K E Y S W I T H T H E D C L - 6 0
The following tables describe the maximum number of line keys supported on each
DT700 model when DCL-60 configuration modes is enabled. It also specifies the
index associated with the first and last DCL-60 Console key. All the keys from key 1 to
key 60 are numbered sequentially.
D C L - 6 0 L E D S
Note:
The LEDs on the DCL-60 Console are updated sequentially starting from the
first key on the module, so if all keys on the phone need to be updated for an
event, there may be a delay between the time the first key is updated and the
time when the last key is updated.
Each key on the DCL-60 Console has two LEDs situated at each corner of the key.
The LED on the left is red, and the LED on the right is green.
Figure 2.28 Left LED
Figure 2.29 Right LED
If the line key is configured to monitor an entry, the LED shows the current presence
state of the entry using red/green color and steady/blinking/flashing light.
D C L - 6 0 W I T H A I T L - 8 L D P H O N E
The DCL-60 console can be connected to an ITL-8LD phone, but the lower LCD on
the phone only shows information for the first 32 programmable keys that are on the
phone. The display does not show any information about programmable keys on the
DCL-60 console.
Product
Name
Model Name
DCL-60
Mode
Max Line
Keys
DCL-60
Console
First Key
Number
DCL-60
Console Last
Key 60
Number
DT730 ITL-12D Enabled 72 13 72
ITL-24D Enabled 84 25 84
ITL-32D Enabled 92 33 92
ITL-8LD Desi-less Enabled 92 33 92