NEC UNIVERGE DT700, User Manual

Page: 87 / 382

. . . . .
B A S I C S E T T I N G S / C O N F I G U R A T I O N
Basic Setup with the Menus and Cursor Pad
DT700 Phone User Guide
4-69
Figure 4.23 Headset ringing options
5
Do one of the following:
• To enable ringing on the headset only, select
2
Headset..
• To enable ringing on the headset and the phoneset, select
3
Phone and Headset.
Figure 4.24 Enable Headset ringing
6
Press Enter
b
on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
Note:
The setting defaults to
1
Phone.
To set the Call Waiting volume
The Call Waiting Volume settings allow you to specify the call waiting tone volume for
the headset.
The range is 0 (no tone) to 19 (maximum tone volume). The default is 19.
Upon entering this screen, the keypad is locked in numeric entry mode. You cannot
change the keypad entry mode in this screen.
1
Press the Menu key.
2
Select
3
User Settings.
3
Select
2
Headset.
Figure 4.25 Select Headset options
4
Select
3
Tone Volumes.