User Guide
133
www.nec-computers.com
Installing and Removing the Hard Disk Drive Cage
Your system is equipped with one of the following types of hard disk drive cage:
■
Cage for Hot-Swap SCSI hard disk drives,
see “Cage for Hot-Swap SCSI Drives”
on page 133
.
■
Cage for Fixed SCSI or S-ATA hard disk drives,
see “Cage for Fixed SCSI or S-
ATA Drives” on page 136
.
Cage for Hot-Swap SCSI Drives
Figure 21: Cage for Hot-Swap SCSI Hard Disk Drives (front view)
A: Thumbscrews
B: Drive carrier release button
Removing the cage
1.
Remove the right side door.
See “Removing the Right Side Door” on page 122.
2.
Remove the front panel.
See “Removing the Front Panel” on page 125.
3.
Remove the 4 thumbscrews (A) holding the cage to the chassis.
4.
Slightly pull out the hard disk drive cage.
5.
Disconnect the data and power cables.
6.
Slide the cage completely out of the chassis.
Cabling the cage
1.
Connect the SCSI cable to the SCSI connector (A).
Summary of Contents for SA2500
Page 1: ... User s Guide SA2500 WA2500 ...
Page 2: ...This page is intentionally left blank ...
Page 252: ...This page is intentionally left blank ...
Page 253: ... ...