User Guide
128
www.nec-computers.com
Installing or Removing Hard Disk Drives
Your system is equipped with one of the following types of hard disk drives:
■
Hot-Swap SCSI hard disk drives,
see “Hot-Swap SCSI Hard Disk Drives” on
page 128
.
■
Fixed SCSI hard disk drives,
see “Fixed SCSI Hard Disk Drives” on page 130
.
■
Fixed S-ATA hard disk drives,
see “Fixed S-ATA Hard Disk Drives” on page 131
.
Hot-Swap SCSI Hard Disk Drives
Installing a Hot-Swap SCSI hard disk drive into a drive carrier
1.
Unlock the front door with the security key, and open the front door.
2.
Locate the slot in which you are going to install a hard disk drive.
The system
has four slots, some of which may already be occupied.
Caution
Make sure to install hard disks starting from the upper slot,
which corresponds to ID 0.
3.
Push the blue release button (B) of the drive carrier to the left, and pull the
lever (A) toward you (roughly at a 30° angle).
4.
Use the lever to gently pull the carrier out of the chassis.
5.
Remove the air dam (C) by pressing with a screwdriver on the tabs inserted
into the screw holes.
6.
Install the hard disk drive into the carrier and secure it with 4 screws, for
instance, two in (E), and two on the other side.
7.
Slide the carrier back into the chassis with the lever still extended as far as it
will go, and then push the lever towards the front of the cage until it clicks into
place.
8.
Close and lock the front door
Summary of Contents for SA2500
Page 1: ... User s Guide SA2500 WA2500 ...
Page 2: ...This page is intentionally left blank ...
Page 252: ...This page is intentionally left blank ...
Page 253: ... ...