User Guide
130
www.nec-computers.com
Fixed SCSI Hard Disk Drives
Installing a Fixed SCSI Drive into the Cage
A: Hard disk drive screws
B: Fan bay
C: Thumb screws
1.
Remove the right side door.
See “Removing the Right Side Door” on page 122.
2.
Remove the front panel.
See “Removing the Front Panel” on page 125.
3.
Remove the 4 thumbscrews (C) holding the cage to the chassis.
4.
Slightly pull out the hard disk drive cage.
5.
Disconnect the data and power cables.
Caution
Be careful when working around the cables connected to the
already installed drives.
When disconnecting cables, but be sure to note which device
each cable or power lead was attached to.
6.
Slide the cage completely out of the chassis.
7.
Locate the slot in which you are going to install a hard disk drive.
The system
has four slots, some of which may already be occupied.
8.
Install the hard disk drive into the slot and secure it with 4 screws, for instance,
two in (A), and two on the other side.
Caution
Make sure to install hard disks starting from the upper slot.
Summary of Contents for SA2500
Page 1: ... User s Guide SA2500 WA2500 ...
Page 2: ...This page is intentionally left blank ...
Page 252: ...This page is intentionally left blank ...
Page 253: ... ...