Technical Information 2-7
OPERATION
The following sections provide basic procedures for starting up and shutting down the
computer.
Starting Up
Power on the system using the following steps.
1.
Plug the monitor power cable into a grounded wall outlet.
2.
Plug the computer’s power cable into the AC power-in connector on the back
panel of the computer and into a grounded wall outlet.
CAUTION:
Ensure that the power service
connection is through a properly grounded
outlet.
NECCSD recommends that you plug the
computer into a surge suppresser for protection
against sudden transient increases or decreases in
electrical power that could damage the
computer’s power supply and result in loss of
data.
If the computer does not turn on, press the power button on the front panel (see
the following figure). Use the lamps on the front panel to verify that the power,
hard disk drive, and LAN connections are working as follows:
Power-on (green)/Sleep mode (yellow)
This LED indicates the operating status of the machine (see Table 2-2).
Table 2-2 Power LED Functions
Color
State
Function
Notes
Off
Off
System is powered
down.
If AC is connected, system
should respond to Wake-Up
events.
Green
Continuous
System is powered on.
This is normal operation mode.
Yellow
Continuous
System is suspended.
This is traditional sleep mode.
Green/
Yellow
Blinking
System is powered on
with a message waiting.
This feature requires a modem
and software support.
Summary of Contents for POWERMATE ENTERPRISE NETPC - SERVICE
Page 6: ...Abbreviations xvii ...
