Option Installation 3-7
4.
Carefully separate the two halves of the chassis by raising the top unit until it
separates from the bottom.
The top unit contains the hard disk, fan, and power supply. The bottom unit
contains the system board and riser card.
5.
Unplug the power supply cable from the connector on the riser card.
6.
Unplug the hard disk data and power cables from their riser card connectors.
Closing the System Chassis
After installing the expansion board, memory module, processor, or hard disk upgrade
options as described later in this chapter, close the chassis as follows.
1.
Connect the hard disk data and power cables to the riser card.
2.
Connect the power supply cable to the riser card.
3.
Lower the top unit into position on the bottom unit.
4.
Secure the two units with the nine screws, three in front and six on top.
5.
Position the front bezel in place on the chassis, aligning the plastic tabs with the
two slots.
6.
Press in on the tabs until they lock into the slots. This secures the bezel on the
chassis.
Figure 3-6 Separating the Chassis Top and Bottom
Summary of Contents for POWERMATE ENTERPRISE NETPC - SERVICE
Page 6: ...Abbreviations xvii ...
