5-14 Disassembly and Reassembly
Replacement
To replace the hard disk drive, proceed as follows:
1.
Complete steps 1 through 7 in the previous subsection.
2.
Install the hard disk in the drive chassis with the four screws.
3.
Attach the power connector from the power supply to the hard disk power
connector.
4.
Attach the IDE cable to the data connector on the hard disk and the IDE
connector on the riser card (see Figure 5-9).
Figure 5-9 Connecting the IDE Cable to the Hard Disk and Riser Card
5.
Reattach the top and bottom halves of the chassis (see “Closing the System
Chassis” in Section 3).
6.
Replace the front bezel (see “Front Bezel”).
7.
Replace the system unit top cover (see “System Unit Top Cover”).
8.
Connect the power cord and monitor and peripheral cables.
Summary of Contents for POWERMATE ENTERPRISE NETPC - SERVICE
Page 6: ...Abbreviations xvii ...
