Disassembly and Reassembly 5-27
Processor
This subsection describes how to remove and replace the processor.
WARNING:
The microprocessor and heat sink
can be hot if the system has been running. Let
the heatsink cool before touching it.
Removal
To remove the processor, proceed as follows:
1.
Turn off the system and disconnect the power cord and all peripheral cables
connected to the system.
2.
Remove the system unit top cover (see “System Unit Top Cover”).
3.
Remove the front bezel (see “Front Bezel”).
4.
Separate the two halves of the chassis (see “Opening the System Chassis” in
Section 3).
5.
Remove the heatsink bail as follows:
Press down on the end of the bail (see Figure 5-23, B) to release tension.
Pry the end of the bail (see Figure 5-23, C) off the retaining clip with a small
screwdriver.)
6.
Lift off the heatsink.
NOTE:
Avoid contact with the thermal grease
normally found between the heatsink and the
processor.
7.
Pull the lever arm on the socket (see Figure 5-23, D) outward until it is free, then
lift the lever arm up to release the processor.
8.
Lift out the processor (see Figure 5-23, A).
Summary of Contents for POWERMATE ENTERPRISE NETPC - SERVICE
Page 6: ...Abbreviations xvii ...
