Jumper Settings B-3
Figure B-1 Locating System Configuration Jumpers
5.
Set the Processor/Bus Speed jumpers for the processor (see the following table).
Change the jumper setting by lifting the plastic block and placing it on the
appropriate pins as shown in the following table. NECCSD recommends using
needle-nose pliers to move a jumper.
Table B-1 Processor Bus Speed Jumper Settings
Processor
Speed
Bus
Speed
J4A1
(Processor)
J6J1
(Bus)
166 MHz MMX
66 MHz
2-3, 5-6
5-6
200 MHz MMX
66 MHz
1-2, 5-6
5-6
6.
Close the chassis (see “Closing the System Chassis” in Section 3).
7.
Replace the system unit cover (see “Replacing the System Unit Cover” in
Section 3).
8.
Power on the system.
Summary of Contents for POWERMATE ENTERPRISE NETPC - SERVICE
Page 6: ...Abbreviations xvii ...
