NEC NVM-CA Series, Integration Manual

Page: 61 / 266

Toshiba Strata DK280
Issue 1-0 Integration Notes
X
57
Toshiba Strata DK280
Integrati on Notes
Required Hardware and Software
Q
Each Voice Mail port must be connected to a Single Line port. Single Line ports are available
on:
•
RDSU (2 Single Line, 4 Electronic Ports)
•
RSTU (8 Single Line Ports)
•
PSTU (8 Single Line Ports)
•
PESU (2 Single Line Ports, 4 Electronic Ports)
Q
Toshiba DKSUB280 KSU with Power Supply
Q
One Common Control Unit PCB Card: RCTUA, RCTUB, or RCTUC/RCTUD
Voice Mail Availability
This phone system is available on these Voice Mail systems:
Q
NVM-22CA with software version 8.01 or higher
Q
NVM-202exCA with software version 7.01 or higher
Q
NVM-2000CA with software version 8.01 or higher
Phone System Programming
Program 10-1 - System Assignments
Ring Transfer, LED 07 - Enable (LED on)
Program 10-2 - System Assignments
•
DTMF Tone Return, LED II - Enable (LED off)
•
Voice Mail ID Code, DTMF Signal Time, LED 06 - Set for 80ms (LED on)
•
Voice Mail MW Cancel via Dial #64/Automatic, LED 04 - Enable (LED on)
Program 12 - System Assignments / Basic Timing
Flash Timing, Code 4 - Set to 0.5 seconds
Program 13 - Defining the Message Center
Use to assign the lowest number Voice Mail port to the Message Center.
Program 15 - Assigning DP/DTMF
Auto-Release (AR) on VM calls, Code 0 - Enable for all CO lines
Program 31 - Station Class of Service
For VM Ports:
•
Toshiba VP (B + Sta #), LED 20 - Enable
•
Toshiba VP (B, No Sta), LED 19 - Enable
•
End/End Signal RCV (VM), LED 17 - Must enable
•
Receive VM ID Code, LED 16 - Enable
•
Toshiba VP Integration (A Tone/D), LED 15 - Enable
•
VM No Conference, LED 09 - Enable (LED on)
•
VM Groups 1 - 4, LED 05-08 - Put all VM ports into Group 1, LED 05 (LED 05 on)
•
VM to VM Call blocking, LED 04 - Enable (LED on)
•
Executive and Privacy Override Blocking, LED 18 - Enable (LED on)
Program 33 - Station Hunting
All VM ports must be set up in a hunt group.