NEC NVM-CA Series, Integration Manual

Page: 11 / 266

Alliance - S
Issue 1-0 Integration Notes
X
7
Alli ance - S
Integrati on Notes
Required Hardware and Software
Q
Hardware:
One Pushbutton Receiver Card: PBR-C(4N)-11KTU
Each Voice Mail port must be connected to an SLT-F(1G)-10ADP, which in turn must be con-
nected to a port on a Regular Electronics Card: ESI-C-(8)-11.
Q
Software:
Any software level is OK.
Voice Mail Availability
This phone system is available on these Voice Mail systems:
Q
NVM-22CA with software version 8.01 or higher
Q
NVM-202exCA with software version 7.01 or higher
Q
NVM-2000CA with software version 8.01 or higher
Phone System Programming
First: About the Voice Mail Extensions
You must connect each NVM port that you want to use to an extension (Keyset) port in the tele-
phone system. All extension numbers assigned to the selected ports must be in the same 10’s group.
For example, all the Voice Mail extension numbers must be in the range 10-19, or 20-29, or 30-39,
etc. Make a note of the selected port and extension numbers, because you will need them for pro-
gramming. The default port-to-extension assignments are in LK4 programming, Data No. 06. You
can also use that Data No. to change the port-to-extension assignments, if necessary.
LK1 System Mode Programming
Data No. 25 - Ring Transfer Selection
Select Yes (which is the default setting).
Data No. 34 - SLT Hookflash Signal Selection
Select Hold (which is the default setting).
Data No 35 - Station Master Hunt Number Selection
Select the first number of the 10’s group that contains the Voice Mail extensions. For example,
if the Voice Mail extensions range between 20 and 29, select 20 as the Station Master Hunt
Number. The Station Master Hunt Number (sometimes called a Pilot Number) lets an exten-
sion user easily reach a Voice Mail extension. The caller only needs to dial the Station Master
Hunt Number from an extension. The phone system automatically “hunts” through all the
Voice Mail extensions and then gives the lowest-numbered available one to the caller.
Data No 64 - SLT Transfer Selection
Select Hangup.
LK1 System Mode Programming
Data No. 01 - SLT Connected Yes/No Selection
Select Yes for each Voice Mail port.
Data No. 03 - Internal Zone Paging Selection
Select None for each Voice Mail port.
Data No. 05 - DTMF/DP SLT Type Selection
Select MF for each Voice Mail port.