NEC NVM-CA Series, Integration Manual

Page: 245 / 266

Lucent Partner II
Issue 1-0 Integration Notes
X
241
Lucent Par tn er II
Integrati on Notes
Required Hardware and Software
Q
Processor must be R3.1 module for inband signaling.
Q
Station/Line 206 Module version R3.1 or higher. This module supports two CO lines and six
extensions and six extensions. The module is required for Message Waiting capability for voice
messages. Each Voice Mail port requires one port from this module. In addition, this module
supports industry standard 2500 sets or Lucent proprietary sets, such as MLS-120.
Voice Mail Availability
This phone system is available on the NVM-2CA Voice Mail system.
Phone System Programming
You will need the Partner II Communications System Programming and User manual to complete
this programming. Most of the required programming is in Chapter 2 of that guide.
Each Voice Mail extension must have Automatic Line Selection set for intercom, which enables the
Partner II to provide intercom dial tone, whenever the Voice Mail port goes off hook.
Partner II system extension numbers overlap with the numbers in the trunk number plan. There-
fore, if trunk mailboxes above trunk 09 are in use, the System Option, Trunk Mailbox Offset, must
be programmed.
General Programming
Program 304 Automatic Extension Privacy
Enable this program for each Voice Mail extension in order to prevent extensions from barging
in on Voice Mail calls that are currently in process.
To have the Automated Attendant answer calls:
Program 607 AA Extensions
Use this program to identify each Lucent Partner extension that will have an AA/VM port con-
nected. This is to notify display set users of a call being handled by Voice Mail ports.
Program 505 Hunt Group Extensions
Use this program to assign the Lucent Partner extensions that will be connected to AA/VM
ports to Hunt Group 7. Only this hunt group sends integration protocol.
Program 206 Group Call Distribution
Use this program to assign the lines that should terminate and be answered by Hunt Group 7
above. To route calls after four rings to a specific user’s mailbox, select VMS Line Cover
(setting 3).
Program 507 VMS Hunt Schedule
Use this program to determine when calls will terminate to Hunt Group 7: Always, Day Only,
or Night Only. This depends on the status of the Night Service Button at Extension 10.