Setting Up the System 2-5
Preparation
!
CAUTION
Ensure that the location of the rack-mount server does not
create an unstable condition when installed in the rack
cabinet.
Before you begin select an appropriate location in your rack cabinet for the
rack-mount server. To improve rack stability, mount heavier items towards the
bottom of the rack cabinet. If the rack is a stand-alone unit and the rack is more
than 75% filled with components, consider installing an optional stabilizer kit.
Note:
When planning your system configuration for the
rack cabinet you should consider the length of the cables
that interconnect system components.
Your server is mounted on a set of slide rail assemblies that allows it to move
freely in and out of the system rack. To mount your server in a rack you must
attach two center slide rails on each side of the server chassis and then install
two rail assemblies in the rack cabinet. The following sections describe how to
assemble the rack-mounting hardware and mount the server in a rack cabinet.
Procedures for installing the cable arm assembly onto the rear of your server are
also included.
Summary of Contents for Express5800/120Rf-2
