4-34
Upgrading Your System
Removing a Disk Array Controller
See "PCI Option Board" for the removal of a disk array controller.
Using Internal Hard Disk Drives in a Disk Array Configuration
To use the internal hard disk drives with a disk array controller, reconnect the
SCSI cables on the system board. The internal hard disk drive interface cable is
connected to the SCSI connector on the system board at shipment.
See Figure 4-33.
SCSI Cabling
To use the internal hard disk drives in a disk array configuration, disconnect the
SCSI cable from the SCSI connector on the system board, and connect it to the
connector of the disk array controller board.
Note:
To switch the internal hard disk drives into a disk array
configuration by installing a disk array controller into the full-height riser
card, connect the SCSI cable to the disk array controller before installing
the riser card into the system board.
A
B
C
D
E
A
SCSI Connector
B
System Board
C
HDD LED Connector
D
SCSI Cable
E
SCSI Backplane
Figure 4-33. SCSI Cable Connections
Summary of Contents for Express5800/120Rf-2
