2-4
Chapter 2: Site Preparation
Checkstand Cutout
When
cutting
the
checkstand
hole,
be
careful
to
maintain
the
specified
dimensions.
The
checkstand
must
be
designed
to
drain
large
spills
of
liquids
away
from
the
base
of
the
scanner.
NCR
recommends
that
an
adjustable
plate
be
placed
between
the
leading
edge
of
the
RealScan
74
and
the
belt
on
the
checkstand.
RealScan 7874-3000/3020 (35.3 cm / 13.9 inch)
35.6 cm
14.0 in
13.0 cm
5.1 in
10.2 cm
4.0 in
29.5 cm
11.6 in
25346
3.2 cm
1.3 in
3.2 cm
1.3 in
3.2 cm
1.3 in
29.5 cm
11.6 in
35.6 cm
14.0 in
Note:
Always treat the scanner's profile under the checkstand as a
rectangular prism (a flat-sided box) when measuring the checkstand for a fit.
Do not take advantage of voids or angles in the design of the scanner base
as NCR reserves the right to change the profile without notice as long as the
change does not impact overall outside dimensions.
10.2 cm
4.0 in
Summary of Contents for 74 OFX (7874)
