NCR 74 OFX (7874), User Manual

Page: 208 / 268

5-100 Chapter 5: Programming
9. Scan the Firmware Flashing tag. Ensure the scanner motor is OFF, the orange
LEDs on the side of the bezel are ON, and the Scan Adviser on top turns pink and
may flash depending on the firmware already in the unit.
Firmware Flashing
24984
This Flash Mode tag is also included in the NCR Scanner Programming Tags
booklet BST0 ‐ 2121 ‐ 74.
10. Select the Run Flash Program button to start the flashing process and select OK
when asked about the cable.
Caution: Do not remove the communication cable while the flashing process is
not completed.
11. The unit should begin flashing. The process should take between 3 and 5 minutes.
Note:
The unit resets itself when it’s done. Reprogramming for the original POS
interface is not needed.
12. Once the flash process is finished, a “Completed Successfully” message will
display on the edit box in the NCR Flash Tool utility and the scanner will restart.
You can also verify if the scanner has been flashed with the desired Firmware
version by selecting the Query Firmware button.
13. Exit the NCR Flash Tool utility and disconnect the scanner from the PC terminal.