NCR 74 OFX (7874), User Manual

Page: 144 / 268

5-36 Chapter 5: Programming
Bar Codes–5
24952
GS1 DataBar Enable
Scans Required
On GS1 DataBar 14
B
A
Disable
0
Enable
GS1 DataBar 14
Only
1
1 Scan
1
2 Scans
2
3 Scans
3
4 Scans
4
1 8
Your Program
Bar Codes - 5 GS1 DataBar
Enable
A
Enable
GS1 DataBar E
Only
2
Enable
GS1 DataBar 14
& GS1 DataBar E
3
Scans Required
On GS1 DataBar E
C
1 Scan
1
2 Scans
2
3 Scans
3
4 Scans
4
UCC-128 Emulation
Mode
D
Normal Mode
0
UCC-128
Emulation Mode
1
B
Scans Required
On GS1 DataBar 14
C
Scans Required
On GS1 DataBar E
D
UCC-128
Emulation Mode
The Bar Codes 5 programming mode contains programming parameters for GS1
DataBar bar codes. Refer to the “Parameter Defaults” section earlier in this chapter for
the factory defined default value of each programming parameter.
GS1 DataBar Enable
This parameter contains 4 selections. Disable reading GS1 DataBar bar codes by
scanning the Hex 0 programming tag.
•
Reading either or both GS1 DataBar–14 and GS1 DataBar–E bar codes is enabled
with this parameter.
•
Read GS1 DataBar–14 only—Scan the Hex 1 programming tag
•
Read GS1 DataBar–E only—Scan the Hex 2 programming tag
•
Read both GS1 DataBar–14 and GS1 DataBar–E—Scan the Hex 3 programming tag
Scans Required on GS1 DataBar–14
This parameter sets the number of scans required to read a GS1 DataBar–14 bar code.
Increasing the number of scans can improve reading nominal bar codes. There are
four settings: 1 scan, 2 scans, 3 scans, and 4 scans. Set this parameter by scanning the
appropriate programming tag, Hex 1 through Hex 4 .