NCR 74 OFX (7874), User Manual

Page: 202 / 268

5-94 Chapter 5: Programming
Clerk Messages Off
1. Program Mode
2. Hex 3
3. Hex 3
4. Hex 0
5. Save and Reset
Note: Because the clerk messages are a subset of the Voice Messages, disabling all
voice messages disables the clerk messages also. All Voice Messages must be enabled
for the Clerk Messages to be enabled.
Following are the three clerk messages.
•
Scale failed, clean under scale deck
•
Scale failed, code 5, clean under scale deck
ƒ
Next, do scale calibration
ƒ
Next, change scale
•
Scale failed, code 4
ƒ
Stop checkstand mechanical vibration
ƒ
Next, change scale
Voice Volume
To change the volume of the voice (speech) on the RealScan 74, scan the following
tags.
•
Program Mode, Hex 5, Hex 7, Hex 0, Save and Reset —Maximum voice volume
•
Program Mode, Hex 5, Hex 7, Hex 1, Save and Reset —High voice volume
•
Program Mode, Hex 5, Hex 7, Hex 2, Save and Reset —Medium voice volume
•
Program Mode, Hex 5, Hex 7, Hex 3, Save and Reset —Minimum voice volume
Volume Adjust Button
The Volume Adjust Button on the Operator Display Panel changes the Good Read
tone volume and frequency (tone). This button can be programmed to work in various
ways.