NCR 74 OFX (7874), User Manual

Page: 113 / 268

Chapter 5: Programming 5-5
END
Function
This tag ends certain input sequences. Since the parameter program determines the
end of most sequences, this tag is not used often.
Indication
•
Scan Adviser Status indicator is initially 3 center LEDs dim green and then flashes
bright green (5 LEDs) showing the tag was read.
•
Short beep as soon as tag is read—Good Read tone.
•
Scanner beeps to indicate it read the End tag, then it says “Program Mode” as it
goes into Program Mode.
HEX 0–HEX F
Function
These sixteen (16) tags enter the selections for each of the parameters in the Parameter
Programs. They also select the Parameter Program
Indication
•
Hex 0— Scanner says “Zero” with no beeps. If voice disabled, scanner produces a
short beep, different frequency from Good Read tone.
•
Hex 1 through Hex F —Scanner says “<tag value>” with no beeps. If voice is
disabled, the scanner produces a number of beeps according to the tag value.
Multiples of 4 short beeps grouped together.
Example: Hex D Scanner says “D”. If voice is disabled, Hex D is indicated by 12
short beeps (3 sets of 4) followed by 1 beep, for a total of 13.
PROGRAM MODE
Function
This tag sets the RealScan 74 into Program Mode. It must be the first tag scanned after
applying power to the RealScan 74, or after scanning the Default tag or the Reset tag.
Indication
•
Scan Adviser Status indicator is initially 3 center LEDs dim green and then flashes
bright green (5 LEDs) showing the tag was read.
•
The scanner says “Program Mode” with no beeps.
•
If Voice NOT enabled, Short beep, long beep, short beep—indicates Program
Mode