NCR 74 OFX (7874), User Manual

Page: 236 / 268

5-128 Chapter 5: Programming
Scanner Cloning Using Programming Tags
The scanner has some programming sequences that let you clone a unit if you did not
get a chance to run the Flash Drive Prep application before going to the site. This
requires programming tags. Follow these steps to perform scanner cloning with
programming tags:
1. Bring a flash drive before going to the site to work on the scanner.
2. Select a scanner from the site–the one you want to clone.
3. Plug the flash drive into the scanner ʹ s USB peripheral port.
4. Use any one of these three sequences to set up the flash drive:
•
PROGRAM MODE
Æ
HEX 7
Æ
HEX F
Æ
HEX C
Æ
SAVE & RESET
This sequence clones the firmware and parameters.
•
PROGRAM MODE
Æ
HEX 7
Æ
HEX F
Æ
HEX D
Æ
SAVE & RESET
This sequence clones Firmware only.
•
PROGRAM MODE
Æ
HEX 7
Æ
HEX F
Æ
HEX E
Æ
SAVE & RESET
This sequence clones Parameters only.
The scanner then resets. Let the scanner copy the requested clone data onto the
flash drive. If the firmware is successfully cloned, the scanner speaks ʺ Load
program in 3 seconds ...2...1...0 ʺ .
5. Select the target scanner.
File Viewer
Every time an operation is performed (Firmware upload, Parameter download,
Memory dump, and so forth), the application creates a log (
.log
) and dump (
.dmp
)
file. This option permits the user to view and delete these files.
1. Select the NCR RealScan Flash Drive Prep Tool icon. The following window
displays.
2. Insert the flash drive to be used. The application detects the flash drive installed.