NCR 74 OFX (7874), User Manual

Page: 86 / 268

3-44 Chapter 3: Installation
Programming RealScan 2357 Hand-Held Scanner if Connected through the
USB Peripheral Port
Prerequisites:
Firmware Levels:
•
7874, 497 ‐ 0461146 ‐ USB HH (pdf417 support not available)
Programming:
Use the following programming sequence if you want to make the scanner beep
whenever it receives a valid barcode data through the USB host port (the scanner does
not beep by default):
Selection Programming Tag Sequence
Enable Programming Mode, Hex 4, Hex 0, Hex 5, Save and Reset
Setting
Disable
Required
Programming Mode, Hex 4, Hex 0, Hex 4, Save and Reset
16386D
If the RealScan 2357 Hand ‐ Held Scanner (any model) is connected to the RealScan 74
through the USB peripheral port, program RealScan 2357 Hand ‐ Held Scanner by
scanning the following bar codes in order.
There is NO programming necessary on the 7874 for this connection.
If it is desired to scan PDF 417 (2D) bar codes with the Hand ‐ Held, you can enable the
RealScan 74 to allow the pass ‐ through of the data without the RealScan 74 itself
having the capability to read that type of bar code.
The following programming sequence is only for USB ‐ configured Hand ‐ Helds:
27023
Selection Programming Tag Sequence
Enable Programming Mode, Hex 7, Hex F, Hex 9, Save and Reset
Disable Programming Mode, Hex 7, Hex F, Hex 8, Save and Reset
Setting
Default