© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
78
Contents
5. Troubleshooting
(continued)
5.3 Fault Code Solutions
(continued)
STR 101
JAM FC3 NOT COVERED
Fault code STR 101, indicates that during a run, the Infeed paper path sensor (FC3), was not covered within timeout after the sheet exit
signal from the previous finisher was detected.
Procedure
Clear paper area, by opening the cover and remove the booklet. Block and unblock Infeed paper path sensor (FC3) with a sheet of
paper.
The Infeed paper path sensor lights up when the sensor is blocked and doesn’t light up when the sensor is not
blocked?
Y N
Go
to
STR 053 FC3 Faulty
.
Make sure that nothing interferes with the paper path and close cover.
STR 102
JAM FC3 NOT UNCOVERED
Fault code STR 102, indicates that during a run, the Infeed paper path sensor (FC3), was covered exceeding timeout.
Procedure
Clear paper area, by opening the cover and remove the booklet.
The Infeed paper path sensor (FC3) is deactivated?
Y N
Go
to
STR 053 FC3 Faulty
.
Make sure that nothing interferes with the paper path and close cover.
STR 103
JAM FC2 NOT COVERED
Fault code STR 103, indicates that during a run, the Paper path sensor (FC2), was not covered within timeout.
Procedure
Clear paper area, by opening the cover and remove the booklet. Block and unblock Paper path sensor (FC2) with a sheet of paper.
The Paper path sensor lights up when the sensor is blocked and doesn’t light up when the sensor is not blocked?
Y N
Go
to
STR 052 FC2 Faulty
.
Make sure that nothing interferes with the paper path and close cover.
STR 104
JAM FC2 NOT UNCOVERED
Fault code STR 104, indicates that during a run, Paper path sensor (FC2), was covered exceeding timeout.
Procedure
Clear paper area, by opening the cover and remove the booklet.
The Paper path sensor (FC2) is deactivated?
Y N
Go
to
STR 052 FC2 Faulty
.
Make sure that nothing interferes with the paper path and close cover.
