© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
45
Contents
5. Troubleshooting
(continued)
5.1 Service program mode
(continued)
5.1.8 Dead cycle
To make one complete Trim cycle.
Dead cycling is a modified machine cycle. All functions in the machine are run such
as motors and solenoids. The program is basically made for factory testing, but can
be of some use when trouble shooting.
Fig.
5.27
Fig.
5.28
No. Action
1
Enter the Service Program mode [see Chapter
5.1
]
2
Use the ‘
▲
/
▼
’ buttons to select ‘Dead cycle’ and press the ‘Enter’ button.
3
Use the ‘Start’ button to select the start the Dead cycle and the ‘Stop’ button to end the Dead cycle.
4
Press the ‘ESC’ or ‘
’ button to exit the Service Program mode and enter the Operator mode.
