© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
119
Contents
7. PCB’S
7.1 Software download
7.1.1 PCB1 MD6DC
INFORMATION
This procedure may delete all Job settings. Make a note of all the settings to make
sure they can be restored after downloading.
WARNING!!!
Turn off the main power switch and unplug the machine before attempting any of the
procedures in this section.
CAUTION!!!
Electrostatic Discharge can cause software crashes,
data and/or communications problems or damage to
electronic components (e.g. : PCBs).
ESD problems can be minimized by maintaining the
machine with ground connections, and proper handling
of circuit boards and sensors. Use ESD Ground Strap for
protection when working with PCBs.
Fig. 7.1
Fig. 7.2
PAY ATTENTION!!!
The right software application can be found in by the list of Factory Settings 2-
Side Trimmer that is present inside the Back Cover.
Downloading
No. Action
Remarks
1
Before downloading software application make sure the list of
Factory Settings 2-Side Trimmer is present inside the Back Cover.
See Chap.
8.1
2
Remove Rear Cover
See Chap.
4.2
3
Check if the dipswitches are in the right position.
See Fig. 7.2
4
Run the right software application for the type of machine and
follow the instructions in the program.
5
After downloading perform a NVM reset and insert the correct NVM
values according to the List in the Back Cover.
See Chap.
8.1
7 PCB’S
(continued)
Contents
1 2 3 4
