© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
104
Contents
6. Default / basic adjustments
(continued)
6.3 Sensors and Switches
(continued)
6.3.4 Adjusting Switches
(continued)
Adjusting S1
No. Action
Remarks
3
Turn the Upper Knives in the position that the Cams are as close as
possible to each other. There should be a space of 1mm between
the Cams.
4
Adjust the Switch (S1) from the Paperstop (Knife blocks Width inner
limit switch) in the middle against the Knife block.
!!!
The Switch has two positions of switching (move in and move
out). When the Switch is moving out the distance between the
LowerKnives on both side must be between 198mm and
199mm.
(See S1)
5
Move the Kniveblocks 5mm outwards (Counter Clock wise =CCW).
6
Then move the Kniveblocks inwards (CW) until the Switch is
moving in. Move the Kniveblocks outwards until the switch is
moving out and stop moving the blocks.
7
Check if the distance between the LowerKnives on both side is
between 198mm and 199mm. Otherwise adjust Switch 1 again until
it switched between 198mm and 199mm.
(See no. 2)
8
Check Side Trim (Finished Size) by continuing Chap.
6.22
.
Move in / move out
1mm
S1
