Mylex Disk Array controller Software Kit 2.01, Installation Manual And User'S Manual

Page: 108 / 172

Mylex Disk Array Controller Driver for UnixWare
5-4 Disk Array Controller Software Kit User’s Manual
☛
Note
CD-ROM or tape drives may be connected to any
channel on the first controller. Do not set the SCSI ID
of either CD-ROM drives or tape drives to ID 0.
2. Initialize all the System drives using the DAC Configuration Utility.
Make sure the first System drive is less than 2GB.
3. Boot the system from the UnixWare Diskette.
4. Follow the instructions provided in the UnixWare 2.1.x Installation
Handbook. The Mylex Disk Array Controller driver for UnixWare is
included on the Software Kit UnixWare (dak) driver diskette which was
made from the distribution CD-ROM.
• During the installation, you will be prompted to either Install Host
Bus Adapter Drivers or Continue Installation.
• Select Install Host Bus Adapter Drivers,
• Insert the Software Kit UnixWare (dak) driver diskette as instructed,
and continue with the instructions provided in the UnixWare
Installation Handbook.
• The controller should be detected automatically during the install
process.
5. After the installation of boot files, the system is automatically shut
down.
Use /dev/rct0 and /dev/cdrom/c0b0txl0 (x is the CD-ROM SCSI ID
number) to access tape and CD-ROM devices after installation.