Murana WSG112, General Instruction Manual

Page: 4 / 75

4
WSG112
ENGLISH
IMPORTANT SAFE OPERATING PRACTICES
6. Do not operate machine while under the influence of alcohol or drugs.
7. Muffler and engine become hot and can cause bums. Do not touch.
8. Exercise extreme caution when operating on or crossing a gravel surface.
9. Stay alert for hidden hazards or traffic.
10. Exercise caution when changing direction and while operating on slopes.
11. Plan your snow-throwing pattern to avoid discharge towards windows, walls,
cars, etc., thus avoiding possible property damage or personal inquiry caused
by a ricochet.
12. Never direct discharge at children, bystanders, and pets nor allow anyone in
front of the machine.
13. Do not overload machine capacity by attempting to clear snow at too fast a
rate.
14. Never operate this machine without good visibility or light. Always be sure of
your footing and keep a firm hold on the handles. Walk. Never run.
15. Disengage power to the auger/impeller when transporting or not in use.
16. Never operate machine at high transport speeds on slippery surfaces. Look
down and behind and use care when in reverse.
17. If the machine should start to vibrate abnormally, stop the engine, disconnect
the spark plug wire, and ground it against the engine. Inspect thoroughly for
damage.
18. Disengage all controls and stop the engine before you leave the operator’s
position (behind the handles). Wait until the auger/impeller comes to
a complete stop before unclogging the chute assembly or making any
adjustments.
19. Never put your hand in the discharge or collector openings. Always use the
clean-out tool provided to unclog the discharge opening. Do not unclog chute
assembly while the engine is running. Shut off the engine and remain behind
handles until all moving parts have stopped before unclogging.
20. Use only attachments and accessories approved by the manufacturer (e.g.
wheel weights, tire chains, cabs etc.). If situations occur which are not covered
in this manual, use care and good judgment. Contact us at 1-877-840-0840 for
advice.
MAINTENANCE AND STORAGE
1. Never tamper with safety devices. Check their proper operation regularly. Refer
to the maintenance and adjustment sections of this manual.
2. Before cleaning, repairing, or inspecting the machine disengage all controls
and stop the engine. Wait until the auger/impeller comes to a complete
stop. Disconnect the spark wire and ground it against the engine to prevent
unintended starting.
3. Check bolts and screws for proper tightness at frequent intervals to keep the
machine in safe working condition. Also, visually inspect machine for any
damage.
4. Do not change the engine governor setting or over-speed the engine. The
governor controls the maximum safe operating speed of the engine.
5. Snowthrower shave plates and skid shoes are subject to wear and damage.
For your safety protection, frequently check all components and replace with
original equipment manufacturer’s (OEM) parts only. Use of parts which do not
meet the original equipment specifications may lead to improper performance
and compromise safety!
6. Check clutch controls periodically to verify they engage and disengage
properly, and adjust them if necessary. Refer to the adjustment section in the
operator’s manual for instructions.
7. Maintain or replace safety and instruction labels, as necessary.
8. Observe proper disposal laws and regulations for gas, oil, etc. to protect the
environment.
9. Prior to storing, run machine a few minutes to clear snow from machine and
prevent freeze up of auger/impeller.
10. Never store the machine or fuel container inside where there is a possibility of
open flame or spark.
11. Always refer to the operator’s manual for proper instructions regarding off-
season storage.