Murana WSG112, General Instruction Manual

Page: 6 / 75

6
WSG112
ENGLISH
2. Put the discharge chute on the chute adapter (
qq, fig.4
).
3. Locate the flanges under the chute adapter, aligning their holes with the holes
on the discharge chute.
4. Fasten six sets of bolts, lockwashers, flat washers, and hex nuts previously
removed.
5. If not already assembled, add the two-pronged metal guard (
yy, fig.5
) to the
chute entrance and fasten with bolts as shown.
ASSEMBLY INSTRUCTIONS
ASSEMBLE THE AUGER CONTROL AND DRIVE
CONTROL CABLES
The Auger Control cable (
r, fig.7
) is located at the left side while that for Drive
Control (
K, fig.7 & 10
) is at the right side.
To assemble the cable for Auger Control, slide the cable connector up over the
end of the nut
Follow the same steps to assemble the Drive Control cable.
IMPORTANT: Refer to Auger Control Test and Drive Control and Shift Lever
prior to operating your snow thrower. Read and follow all instructions carefully
and perform all adjustments to verify your snow thrower is operating safely and
properly.
ASSEMBLE THE SHIFT ROD
1. Remove the hairpin clip and flat washer from the lower shift rod ( ff, fig.7&17
).
2. Slide the lower shift rod through the shift arm (
hh, fig.7&17
).
3. Check the upper end of the shift rod under the control panel. If not already
assembled, be sure there is a lock nut (
uu, fig.6
) snugged up tight against the
rod attachment.
4. Insert the flat washer removed earlier
5. Secure with the hairpin clip removed earlier.
6. Remove the hairpin clip and flat washer from the upper shift rod (
dd, fig.7&17
).
7. Slide the shift rod connector (
gg, fig.7&17
) down over the upper end of the
lower shift rod.
8. Tap the connector until it locks on the lower shift rod.
9. Insert the flat washer removed earlier
10. Secure with the hairpin clip removed earlier.


!