18
WSG112
ENGLISH
WARRANTY
All products distributed by Airco Hong Kong Ltd. are warranted against
manufacturers’ faults and defects for a period of one year from the date of
purchase by the end user. The Company will REPAIR OR REPLACE, AT ITS OWN
OPTION, merchandise deemed by the company to be defective, provided that
is has not been misused, abused, altered, or repaired by anyone other than an
authorized repair centre. Retain proof of purchase. Return the defective product to
the place of purchase.
This warranty does not extend to parts deemed consumables, such as brad and
staple gun driver blades, grinding discs, electric motor brushes, welding contact
tips, etc. All warranty claims must have prior authorization and must be shipped
prepaid to an authorized repair depot, accompanied by a copy of the invoice
specifying the date that the item was sold to the end user. You should take any tool
with a problem back to where you purchased it, accompanied by your receipt.
Airco Hong Kong Ltd.
Tel: 877.840.0840
!
OFF- SEASON STORAGE
WARNING: Never store the machine or fuel container indoors where there is an
open flame, spark, or pilot light such as on water heater, furnace, clothes dryer,
or other gas appliance.
WARNING: Drain fuel into an approved container outdoors, away from an open
flame. Allow engine to cool. Extinguish cigarettes, cigars, pipes, and other
sources of ignition prior to draining fuel.
Fuel left in engine for extended periods deteriorates and will cause starting
problems.
If unit is to be stored over 30 days, prepare for storage as follows:
1. Remove gasoline from carburetor and fuel tank to prevent gum deposits from
forming on these parts and causing possible malfunction of engine.
2. Run engine until fuel tank is empty and engine stops due to lack of fuel.
3. Drain carburetor by pressing upward on bowl drain, located below the
carburetor cover.
NOTE:
Fuel stabilizer is an acceptable alternative for minimizing the
formation of fuel gum deposits during storage. Do not drain carburetor if
using a fuel stabilizer.
4. Wipe equipment with an oiled rag to prevent rust.
5. Remove spark plug and pour one ounce of engine oil through spark plug
hole into the cylinder. Cover spark plug hole with rag. Crank engine several
times to distribute oil. Replace spark plug.
6. Follow the lubrication recommendations found in the
Maintenance
section.
7. Always store the snowthrower in a clean, dry area.
NOTE: When storing any type of power equipment in an unventilated or metal
storage shed, care should be taken to rust-proof the equipment. Using a light
oil or silicone, coat the equipment, especially any chains, springs, bearings and
cables.
WARNING: Repairs should be made by an authorized repair centre. Opening
this tool could invalidate your warranty.
NOTE: With regard to the warranty, the following are deemed consumable parts:
cotter pins, shear pins, shave plate, auger belt, skid shoes, etc., and thus not
covered.
SERVICING
!
!
Summary of Contents for WSG112
