Murana WSG112, General Instruction Manual

Page: 19 / 75

v.090220
19
ENGLISH
PROBLEM CAUSE REMEDY
Engine fails to start Fuel tank empty, or stale fuel. Fill tank with clean, fresh gasoline. Fuel
becomes stale after thirty days.
Blocked fuel line Clean the fuel line.
Choke/Run button not in the CHOKE
position. Move button to CHOKE position.
Faulty spark plug Clean, adjust gap or replace.
Spark plug wire disconnected. Connect spark plug wire
Primer button not being used properly. refer to the engine manual
Engine runs erratically Unit running on CHOKE Move the CHOKE/RUN button to RUN.
Blocked fuel line or stale fuel
Clean the fuel line; fill the tank with clean
fresh gasoline.
Water or dirt in the fuel system
Drain the fuel tank and carburetor. Refill
with fresh fuel.
Loss of power Spark plug wire loose Connect and tighten spark plug wire.
Gas cap vent hole plugged Remove ice and snow from gas cap. Be
certain vent hole is clear.
Excessive vibration Loose parts or damaged auger. Stop the engine immediately and
disconnect the spark plug wire. Tighten
all bolts and nuts. If vibration continues,
have the unit serviced by an authorized
service dealer.
Unit fails to propel itself D r i v e c o n t r o l c a b l e i n n e e d o f
adjustment. Adjust drive control cable. Refer to
Making Adjustment Section.
Drive belt loose or damaged. Replace drive belt. Refer to a service
centre or call 1 (877) 840-0840.
Unit fails to discharge snow Chute assembly clogged Stop engine and disconnect spark plug
wire. Clean chute and inside of auger
housing with clean-out tool or a stick.
Shear pins sheared Replace shear pins.
Foreign object lodged in auger. Stop engine immediately and disconnect
spark plug wire. Remove object from
auger.
A u g e r c o n t r o l c a b l e i n n e e d o f
adjustment. Adjust auger control cable. Refer to the
Making Adjustment Section.
Auger belt loose or damaged. Refer to a service centre or call 1 (877)
840-0840
.
TROUBLESHOOTING