MSA SUPREMATouch MCP 20, Operating Manual

Page: 138 / 241

138
Installation
GB
SUPREMATouch
Configuration MAR30/MGR30
The MAR30/MGR30 module is shipped factory-configured. No provisions are made for changing
the configuration.
Within the scope of the installation and start-up of the system or of the replacement of the MAR30/
MGR30 module, however, the switch setting (S100 set to all OFF) illustrated in Figure Fig. 76
must be checked and corrected if necessary.
The module MAR30/MGR30 is furnished with a boot loader for installing new firmware.
Fig. 76
Configuration MHS30
No configuration
Configuration MBC20 Module
The MBC20 module is shipped factory-configured. No provisions are made for changing the
configuration.
Within the scope of the installation and start-up of the system or of the replacement of the
MBC20 module, however, the switch setting (S500 set to all OFF) illustrated in Figure 77 must be
checked and corrected if necessary.
The module MBC20 is furnished with a boot loader for installing new firmware.
Switch S100
1 2 3 4
OFF OFF OFF OFF Factory setting for standard operation mode
OFF OFF OFF ON
Setting for compatibility mode (operation with
MDA); MAR only
ON X X X Boot loader active
X X X X Reserved
The normal function of the module is deactivated in boot loader mode. This mode should
therefore be used only by MSA service personnel!
Switch S500
1 2 3 4
OFF OFF OFF OFF Factory setting / operation on CAN A
OFF OFF OFF ON operation on CAN B
ON X X X Boot loader active
X X ON ON Reserved