MSA SUPREMATouch MCP 20, Operating Manual

Page: 36 / 241

36
Entering System Parameters
GB
SUPREMATouch
Field Field Type Function
Relay Selection
Contains a list of all available relay outputs. After an output
number is selected, the rest of the window is filled, if
settings have already been entered for that output.
If an output number is selected that has not been configured
before, the settings from the last displayed output remain
and are used as the preliminary settings for the new output.
This makes it easy to copy the settings from one output to
another. If an output is displayed that has not yet been
configured, default values are used as the preliminary
settings.
This input field can be accessed without a key switch or
password if an output has been selected for which parame-
ters have already been set. If a number is entered that has
not been used before, authorization with a password or key
switch is required.
When first opened, the field contains the relay output that
was last selected in the Measuring Point window.
Tag
text, 10 charac-
ters; empty by
default
Enter a customer-specific designation for the selected relay
output.
Normal run
Selection,
default is closed-
circuit
Set the operating mode for the selected relay output:
• Closed circuit (normally energized):
The relay coil is energized in the no alarm status and is
de-energized in the alarm status.
• Open circuit (normally de-energized):
The relay coil is de-energized in the no alarm status and
is energized in the alarm status.
blinking
Checkbox, not
set by default
If enabled, the relay flashes at a frequency of approx.
0.5 Hz when activated until the alarm is acknowledged. This
function doesn't work combined with the inhibit condition.
New Alarm
Checkbox, not
set by default
If enabled, the relay output selected can be set to the status
defined by the input field Normal Run by acknowledging the
selected conditions, even if the conditions are still pending.
Point based
voting Checkbox, not
set by default
If enabled, the counting for the voting is done by counting
the effected measuring points instead of the effected condi-
tions.