MSA SUPREMA Touch, Installation & Maintenance Instructions Manual, Page: 28 / 309

MSA AUER
MSA
Operation of the System
SUPREMATouch 27 US
The following input data is shown in this display:
No. The number of the measured input in the system. This number is set by the sys-
tem and cannot be changed by the user.
Tag The customer defined input description is displayed here.
Value Numerical value and dimension of measurement. The measured values are dis-
played in intervals of 1 second, as long as they are within the measuring range. If
the measuring range is exceeded, the highest value reached is retained. In the
case of signal failure or an alarm suppression [during the warm-up period of spe-
cific sensor types], dashes are displayed instead of the measured value.
Status Current status of the input. The status is updated at intervals of 1 second and the
following values can be displayed:
-
“Measure”
-
“Calib.” [ measurement point in calibration mode]
-
“Inhibit” [measurement point inhibited]
-
“Overflow” [Measured value above full scale]
-
“SignalErr.” [Measured value below measurement range, or value missing]
-
“SystemErr.” [It was not possible for the MDO to get the measured value]
-
“PA-failed” [presetting error]
-
For specific sensor types, text can be defined for special statuses. These are
labelled with "F:“ [e.g. "F:OpticErr"]. The property is then equivalent to "Signal
error".
-
“suppressed” [alarm suppressed during warm-up period of specific sensor
types]
-
alarms 1, 2, 3 and 4
-
Free [sensor has not been installed]