MP Filtri UFM Series, Use & Maintenance Manual

Page: 83 / 136

UFM091
To commission the ICM, switch on the auxiliary pump and the particle counter using the selector in the electrical panel (Fig. 14),
then wait 5 minutes after switching on before counting. To carry out the count, activate the particle counter button (Fig. 15).
6.4.4 Oil analysis with particle counter
The ICMWMKUG12.0 series particle counter versions allow contamination counting and classification according to the international
standards ISO4406 - NAS1638 - AS4059 Tab.1 - AS4059 Tab.2.
The particle counter also supplies the value of the water content in the oil and the temperature via an internal sensor.
It is possible to program the particle counter by connecting it via the ICMUSBI module (supplied) to a Personal Computer.
It is possible to enter a default value for the cleanliness class (according to the regulations used).
When this value is reached, the unit switches off automatically.
NOTE
The instruction manual, the programming of the particle counter, the software and the installation drivers are contained
in the included USB stick in the section "ICM User Manual".
NOTE
Before starting the particle counter auxiliary pump, make sure that the main pump has been running
for about 5-6 minutes and that the hoses are full of oil.
CAUTION
!
Start/Stop
auxiliary pump
for particle counter
Manual activation of
particle counter
Motor/pump assembly and pressure relief
valves for the use of the particle counter
Fig.14 Fig.15
6.4.3 Air vent
When the unit is first turned on after inserting the filter element, vent the air inside the filter body using the vent valve (Fig. 13) on
the cover. Once the air has been removed, close the vent valve.
Air vent Fig.13
Collect the oil in a container and dispose of it in accordance with the regulations in force.
NOTE
!
Mobile filtration unit
81