MP Filtri UFM Series, Use & Maintenance Manual

Page: 122 / 136

6.4 U
se
6.4.1 Installation
The mobile filtration unit must be positioned in a place that guarantees its stability during use.
TRANSFER
Connect/immerse the metal suction lance (IN) to the tank or to the drum, immerse the discharge hose (OUT) in the machine tank
or in the drum which should be transferred to.
If the transfer oil has to be cleaned, it is advisable to filter the oil contained in the drum or tank several times before being
transferred.
In this case immerse the metal suction lances (IN) and the discharge lances (OUT) in the drum or oil tank to be transferred. Be
careful that the lances remain below the level of the oil to be transferred in order to avoid foaming and cavitation; space the ends
of the two lances as far as possible from each other in order to recirculate all the fluid and not generate an emulsion.
FILTRATION
Immerse the metal suction lances (IN) and the discharge lances (OUT) inside the tank far from each other, possibly positioning them
at different heights (100 mm suction from the tank bottom, immersed delivery for a minimum of 200 mm).
Make sure that the tubes/lances are properly fixed or perfectly stable before starting.
Be careful not to mix up the suction and discharge hoses. The suction hose (IN) is the one with the largest diameter.
The discharge lance must in general have unrestricted flow. It is prohibited to install taps or components on both
hoses that may obstruct or reduce the flow of the fluid.
CAUTION
!
Mobile filtration unit
120