MP Filtri UFM Series, Use & Maintenance Manual

Page: 119 / 136

UFM919
6 Installation procedures and general operation
6.1 Introduction
The mobile fi ltration units are suitable for the following fl uid operations:
- Transfer with fi ltration
- Off-line fi ltration (maximum recommended volume 1800/2700L)
Scope of supply Fig.1 Endcap with bypass Fig.2 Blind endcap Fig.3
With the bypass valve blocked pay close attention to the clogging indicator. As soon as the indicator indicates the
clogged fi lter, turn off the fi ltration unit and replace the fi lter element.
CAUTION
!
The standard version of the fi ltration unit is
delivered without a fi lter element, before its use
install an original MP Filtri fi lter element suitable
for the type of unit being used (see fi lter element
codes listed in Table 6.7.2 Item.5) and carry out the
procedures described in Section 6.2 "Filter element
installation".
The fi lter bypass valve can be locked by replacing
the endcap with bypass (Fig. 2) with the included
(Fig. 1) blind endcap (Fig. 3).
The endcap is inserted into the fi lter element.
Fig.4
Fig.5
6.2 Filter element installation
Loosen the air vent nut
Insert the fi lter element into
the fi lter body Screw on the cover
Choose endcap with bypass
or blind endcap
Make sure the air vent is closed
Insert the endcap with bypass (Fig. 4) or the
possibly selected blind endcap (Fig. 5) in the
fi lter element
3
7
4 2
6
1
5
These operations must be performed
with the machine off. Do not turn on
the unit without fi rst installing
the fi lter element.
CAUTION
!
We recommend using only
original MP Filtri fi lter cartridges.
NOTE
!
Unscrew the cover
Mobile fi ltration unit
117