MP Filtri UFM Series, Use & Maintenance Manual

Page: 37 / 136

UFM041
FILTRATION
Immerse the metal lances for suction (IN) and for discharge (OUT) inside the tank far from each other, if possible positioning them
at different heights (100 mm suction from the bottom of the tank, discharge immersed a minimum of 200 mm).
Make sure that the tubes/lances are properly fixed or perfectly stable before starting.
Be careful not to mix up the suction and discharge hoses. The suction hose (IN) is the one with the largest diameter.
The discharge lance must in general have unrestricted flow. It is prohibited to install taps or components on both
hoses that may obstruct or reduce the flow of the fluid.
CAUTION
!
Operate the rotary knob for a few seconds and observe the direction of rotation. The direction observed on the fan side
must be clockwise, otherwise the phases L1 and L2 must be inverted.
NOTE
6.4.2 Power on
Electrical connection for the
single-phase motor Electrical connection for the
three-phase motor (5 poles plug)
Insert the electric plug into a socket.
Check the direction of rotation in the version with three-phase motor.
Three-phase electric power supply with protective conductor is required for the power supply of the trolley.
After inserting the plug, turn the rotary knob for turning on and off to "I" on the terminal box of the motor (Fig. 1).
At this point the transfer and filtration of the fluid begins.
CAUTION
!
Before starting up the electric motor, make sure that the suction lance (IN) is immersed in the fluid.
NOTE
Rotary knob
ON/OFF
Fig.1
6.4.3 Air vent - not applicable for UFM041
6.4.4 Oil analysis with particle counter - not applicable for UFM041
5 poles plug for
the three-phase motor
Mobile filtration unit
35