Motortech DetCon series, Operating Manual

Page: 82 / 90

8 DenEdit Settings
82 Rev. 02/2019
Enable max. output setting
Activate the checkbox to limit the signal of the analog outputs to the value in the field Maximum
output value .
Enable knock LED latch (switch ON/OFF to reset)
Activate the checkbox so that the status display ENGINE KNOCKING remains lit when knocking is
detected which falls below the
Ignition reduction limit . With this setting, the cylinder which
triggered the knocking can still be identified after the engine is shut off. In order to delete the
status display, deactivate the checkbox and activate it again.
Enable bad sensor detect
Activate the checkbox so that defective detonation sensors are indicated via the status display
BAD SENSOR. This function only detects sensors which provide faulty signals. If a wire has
ruptured or a sensor gives no signals for some other reason, it is not indicated on this display. If
a defective sensor is detected, the binary output
TRIP is also activated.
Trip contact inactive (CLOSE, OPEN)
Using this setting, you can specify whether the binary output TRIP is open during normal
operation and closed when the
Immediate Stop Limit is exceeded (setting: OPEN) or vice versa
(setting: CLOSE).
8.8.6 Tab: CAN Params
Communication mode
Depending on the device connected, select the mode CANOpen mode or Intelli-controller .
CAN address
Enter the CAN address with which the device will be identified in the CAN bus.
Bus speed
Enter the transmission speed that was set for the CAN bus.