5 Installation Instructions
56
Rev. 02/2019
5.5
Mounting the Camshaft Sensor
In diesel and pilot injection engines, camshaft sensors are used to determine the fuel injection
timing instead of the ignition sensor units used for gas engines. The camshaft must be prepared
in such a way that the inductive camshaft sensor receives the rising signal at the injection point
(+/- 5°). Mounting possibilities allowing for the reception of the required signal differ according
to the engine type. It may be necessary, for example, to insert a screw or drill a hole into the
camshaft or install a trigger wheel.
It is possible to install PNP and NPN sensors. In both cases, the input resistance must be 1 k
(i. e. the
Load Resistance
jumper is removed). The following photo shows an example of such an
installation.
Calibration for diesel and pilot injection engines
For diesel and pilot injection engines, calibration must be performed by
MOTORTECH service personnel.
Summary of Contents for DetCon series
