8 DenEdit Settings
80
Rev. 02/2019
–
Ref. filter frequency
Normal frequency of the engine without knocking.
–
Attenuation
Balance between the reference signal (background noises and normal engine vibration) and
the knocking signal.
–
KNOCK, REF
Selection of whether the knocking signal (in %) or the reference signal (in %) should be
shown on the knocking intensity display.
8.8.3
Tab: Input Gains
This tab is only available to you if the selected device software is version 2.0 (firmware, see
status line) or higher (menu
Controller
). The settings in this tab allow you either to amplify the
input signals of the individual detonation sensors or to attenuate them (values <100) in order to
suppress signals similar to knocking signals. Values between 0 and 300 can be specified. The
default setting is 100. This value can be restored via the button
Default
.
8.8.4
Tab: Firing Sequence
This tab is only available to you if you have selected the device software version 2.0 (firmware,
see status line) or higher (menu
Controller
) and selected the setting
Irregular
as
Engine type
in
the tab
Knocking Params
. You have the option of entering a freely definable firing sequence. Via
the button
Default
, settings are set to conform to an in-line engine. This basic setting can be a
good starting point for entering your individual deviations.
Summary of Contents for DetCon series
