MOTO GUZZI California 1400, Instructions Manual

Page: 217 / 411

Checking the clutch actuator
If the clutch is replaced, measure the length of the
clutch control rod in order to use the correct rod.
Measure as follows:
•
Fit the new clutch on the crankshaft.
•
Fit the clutch control bowl in the gear-
box.
•
Fit the gearbox on the engine block.
•
Fit the tool in the gearbox to determine
the clutch control rod length.
•
Measure rod protrusion using a depth
gauge (see picture).
•
According to the value found, select
the correct rod based on the following
table:
Specific tooling
020678Y Tool for clutch rod checking
CLUTCH CONTROL ROD SELECTION
Specification Desc./Quantity
Protrusion: 9.8 - 11.2 mm (0.386 - 0.441 in) Clutch control rod length = 183 mm (7.205 in)
Protrusion: 9 - 9.7 mm (0.354 - 0.382 in) Clutch control rod length = 184.5 mm (7.264 in)
Protrusion: 8.25 - 8.95 mm (0.325 - 0.352 in) Clutch control rod length = 185 mm (7.283 in)
Protrusion: 7.5 - 8.2 mm (0.295 - 0.323 in) Clutch control rod length = 185.5 mm (7.303 in)
Protrusion: 6.75 - 7.45 mm (0.266 - 0.293 in) Clutch control rod length = 186 mm (7.323 in)
Protrusion: 5.3 - 6.7 mm (0.209 - 0.264 in) Clutch control rod length = 187.5 mm (7.382 in)
Assembling the clutch
•
Lock crankshaft rotation with the
crankpin facing upwards.
•
Place the clutch plate with the refer-
ence facing upwards.
•
Fasten the clutch plate on the crank-
shaft with the six screws with Loctite
243.
CAUTION
DURING REMOVAL/FITTING OF THE SCREWS DO NOT
USE WASHERS IF PREVIOUSLY INSTALLED.
California 1400
Engine
ENG - 217