Moeller Rapid Link, Switching And Installation System, Page: 156 / 162

Appendix
01/08 AWB2190-1430GB
152
Optional accessories
Lock shackle SET-M-LOCK
If the plant operator requires an isolating device and locking
facility for padlocks at each motor, you can use lock shackle SET-
M-LOCK. With this lock shackle, motor cables SET-M3… and
SET-M4… can be safely isolated from the power supply with one
or two padlocks with a hasp thickness up to 8 mm.
In connection with motor starters RA-MO and speed control units
RA-SP the lock shackle meets the requirements of IEC/EN 60204-
1:
• for mains isolating devices up to 16 A according to section 5.3
• for power switches to prevent unexpected starting according to
section 5.4
• for isolating equipment for electrical apparatus according to
section 5.5
• for protection from inadvertent and/or accidental closing
according to section 5.6
The lock shackle can be fitted next to any motor starter RA-MO
and speed control unit RA-SP with one or two 90° countersunk
M5 screws (e.g. to ISO 2009 or ISO 7046).
Alternatively, the lock shackle can be made available as an
accessory to maintenance personnel.
Procedure:
X
Set the key-switch of the motor control unit (RA-MO or RA-SP)
to its OFF position .
X
Wait until the motor has come to a complete halt .
X
Undo the lock shackle of the motor feeder and disconnect the
motor plug from the motor control unit .
X
Insert the motor plug into the lock shackle and secure it with
your padlock .
1
2
3
4
5
Figure 154: Fitting the lock shackle
0,3A 1011
0,4A 0111
0,6A 1000
0,8A 0100
1,0A 1100
1,2A 0010
1,5A 1010
1,7A 0110
1,9A 1110
2,1A 0001
2,6A 1001
3,6A 0101
5,0A 1101
6,6A 0011
ASi 03 I 3 I 4
0
L R 0
1
ON DIP
2 3 4 5 6 7 8
1
0
RA-MO...W
L1
⇒
T1
L3
⇒
T3
L1
⇒
T3
L3
⇒
T1
0
1
1
3
2
M
3 h
STOP