Moeller Rapid Link, Switching And Installation System, Page: 121 / 162

01/08 AWB2190-1430GB
RA-SP and keypad DEX-KEY-10
117
Jog Mode 0
A39
Jog Mode
= stop mode in jogging (inching) duty
Not used with RA-SP
rw STOP
ADJ 80
b81
ADJ
= (Analog adjustment)
Not used with RA-SP
rw online
PANEL d01
b89
PANEL
= panel display value for DE5-KEY-R03.
d01
= actual frequency [Hz]
d02
= Motor current (I0) [A]
d03
= direction of rotating field (R, F)
d04
= PID actual value
d05
= Status of digital inputs (1 to 5)
d06
= status of digital outputs (fault signal, 11, 12)
d07
= display value [Hz] (output frequency
x
factor)
ro
rw
1)
–
online
1)
TERM LLL LLLLL
– TERM = (terminal) signal state of internal control inputs
H = (High) input/output energized
L = (Low) input/output not energized
LLL = Fault signal and internal message
HLLLL = PTC (function enabled)
HLLLH = PTC, switch positions HAND and FWD
HLLHL = PTC, switch positions HAND and REV
HLHLL = PTC, switch positions AUTO and AS-Interface
®
Q2 = 1
HHLLL = PTC, switch positions AUTO and AS-Interface
®
Q3 = 1
HHHLL = PTC, switch positions AUTO and AS-Interface
®
Q2 = 1 and Q3 = 1
ro –
ERR1
---
– ERR1 = last fault message
_ _ _ = Type of detected fault, frequency on fault, current on fault, DC link
voltage on fault [Vdc] ro –
ERR1 0.0Hz
– 0.0Hz = frequency on fault ERR1 ro –
ERR1 0.0A
– 0.0A = current on fault ERR1 ro –
ERR1 000.0Vdc
– 000.0Vdc = DC link voltage on fault ERR1 ro –
ERR1 RUN 000000H
– RUN 000000H = operating hours on fault ERR1 ro –
ERROR COUNT 000
– ERROR COUNT 000 = number of faults to date ro –
ERR2
---
– ERR2 = last but one fault message; additional indication as for ERR1 ro –
ERR3
---
– ERR3 = second from last fault message, additional indication as for ERR1 ro –
You can configure the Monitor menu to display the following additional information:
FS 000.0F 0.0Hz
– FS = frequency setpoint through keypad DEX-KEY-10 rw online
1S 000.0F 0.0Hz
1S to 3S = fixed reference frequency 1 to 3 (4 to 15 are not used with RA-SP) ro –
ACC2 0015.0S
A92 ACC1 = second acceleration time from 0 Hz to end frequency; displayed only
when enabled (
a F06)
rw online
DEC2 0001.5S
A93 DEC2 = second deceleration time from end frequency to 0 Hz; displayed on ly
when enabled ( a F06)
rw online
PNU = parameter number of frequency inverter DF5
ro = parameter is read-only
rw = parameter is read/write
online = changed values take effect immediately
STOP = settings can be changed only at standstill (output frequency = 0: selector switch in OFF position or STOP key pressed).
Display text DF5
PNU Meaning Access
rights Change