Moeller DV6-340 Series, Manual

Page: 5 / 221

Contents
01/02 AWB8230-1415GB
2
4 Operating the DV6 45
Initial startup 45
LCD keypad 46
Operation with LCD keypad 46
– Menu overview 47
– Changing display and Basic parameters 48
– Changing the parameters of the extended
parameter groups 48
Display after the supply voltage is applied 49
Connection examples 50
– Operation using an external potentiometer 50
– Operation through an analog setpoint value 50
– Operation with fixed frequencies 51
Operational warnings 52
5 Programming the control signal terminals 53
Overview 53
Analog outputs – AM, AMI and FM 58
– Voltage output (AM) 58
– Current output (AMI) 59
– Frequency output (FM) 59
Analog inputs, terminals O, O2 and OI 61
– Frequency setpoint definition 61
– Matching of terminals O, O2 and OI 62
– Analog setpoint value matching 63
Programmable digital inputs 1 to 8 66
– Start/stop 68
– Fixed frequency selection (FF1 to FF4) 69
– Bitwise fixed frequency selection (SF1 to SF7) 71
– Analog input changeover (AT) 73
– Second time ramp 2CH 74
– Controller inhibit and coasting (free run stop – FRS) 75
– External fault message (EXT) 76
– Unattended start protection USP 77
– Reset (RST) 78
– Jog mode (JOG) 79
– Change over vector parameters (CAS) 81
– PTC/NTC thermistor input, terminal TH 82
– Software protection (SFT) 83
– Motor potentiometer functions: accelerate (UP) –
decelerate (DWN) – Reset frequency (UDC) 84
– Use second and third parameter set (SET/SET3) 86
– Activate DC braking DB 88
– Change over current limit (OLR) 90
– Heavy mains starting (CS) 91
– Setpoint value through keypad (OPE) 93
– Torque limitation (TL), torque selection (TRQ1 and TRQ2) 94
– Three-wire control (STA – STP – F/R)
96
– Activating/deactivating PID control (PID)
Resetting PID and integral component (PIDC) 97
– Changeover from PI to P control (PPI) 98
– Brake enable confirmation (BOK) 100
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616