Moeller DV6-340 Series, Manual

Page: 69 / 221

Programming the control
signal terminals
01/02 AWB8230-1415GB
66
Programmable digital inputs 1 to 8
Various functions can be assigned to terminals 1 to 8. Depending
on your requirements, you can configure these terminals as
follows:
• anticlockwise start signal (REV),
• selection inputs for various fixed frequencies (FF1 to FF4),
• reset input (RST),
• etc.
The terminal functions for programmable digital inputs 1 to 8 are
configured with PNU C001 to C008, i.e. with PNU C001, you
specify the function of digital input 1, with PNU C002 the function
for digital input 2, etc. Note, however, that you cannot assign the
same function to two inputs at the same time.
Programmable digital inputs 1 to 8 are configured by default as
make contacts. If, therefore, you want to activate the function of
an input terminal, you must close the corresponding input (i.e.
connect the input terminal to terminal P24). Conversely, to deac-
tivate the input terminal, the input must be opened.
Table 10: Digital inputs 1 to 8
For a detailed description of the input functions, see the pages
listed in Table 11.
Table 11: Functions of the digital inputs
Caution!
If an EEPROM error occurs (fault message
E 008
), all
parameters must be checked to ensure that they are
correct (particularly the RST input).
PNU Terminal Adjustable in RUN
mode Value WE
Normal Extend
ed
C001 1 – j a Table 11 18
C002 2 16
C003 3 06
C004 4 11
C005 5 09
C006 6 03
C007 7 02
C008 8 01
Value Function Description a Page
01 REV Start/stop anticlockwise
operation 68
02 FF1 First fixed frequency input 69
03 FF2 Second fixed frequency input
04 FF3 Third fixed frequency input
05 FF4 Fourth fixed frequency input
06 JOG Jog mode 79
07 DB DC braking 88
08 SET Selection of the second
parameter set 86
09 2CH Second acceleration and
deceleration time 74
11 FRS Motor shutdown and free run
stop (coasting) 75
12 EXT
External fault 76
13 USP Unattended start protection 77
14 CS Heavy starting duty 91
15 SFT Parameter protection 83
16 AT Setpoint definition through
current signal 73
17 SET3 Third parameter set 86
18 RST Reset 78
20 STA Pulse start (3-wire) 96
21 STP Pulse stop (3-wire) 96
22 F/R Direction of rotation (3-wire) 96
23 PID Activation of PID control –
24 PIDC Reset integral component –
26 CAS Motor parameter changeover –
27 UP Acceleration
(motor potentiometer) 84
28 DWN Deceleration
(motor potentiometer) 84
29 UDC Reset frequency
(motor potentiometer) 84
31 OPE
Setpoint value through keypad 93
32 SF1 Bitwise frequency selection 71
33 SF2
34 SF3
35 SF4
36 SF5
37 SF6
38 SF7
39 OLR Current limit switch over 90
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616