MOBA MOBA-Matic MMC-1000, User Manual

Page: 96 / 172

96
Operation
8.3.3 Actual value adjustment
Definition The slope sensor should be parallel to the bottom edge of the tool
during assembly. As this is not always 100 percent possible in
practice and sometimes an offset remains, the sensor will be
subsequently calibrated in the system.
Once the
“Offsets” between measured value and reality have
been determined, the slope sensor then exactly indicates the
slope of the tool again. We are talking about the actual value
adjustment here.
Procedure: Actual value adjustment during automatic mode
The system is
located in
automatic mode
(
“AUTO” function
lamp is on). Here
in our example,
the control works
with a setpoint
value setting of
2.45%.
The results of the
work will be
measured again
with a highly
accurate digital
spirit level.
According to the
above
presentation, this
determined actual
value is actually
only 2.30%.
Press the enter key
and hold it down.
Initially
“SEt” will
appear in the
display, then the
display changes
back to the
numerical value.
The Enter key will
remain pressed
and the value
displayed will be
corrected with the
UP/DOWN
buttons to the
determined actual
value (2.30%)
under 2.
2 , 3 0
1)
2)
3)
4)