Mitsubishi MELSEC-F FX-TRN-BEG-E, User Manual

Page: 25 / 164

FX-TRN-BEG-E Outline of the Lesson Plan 2
A-19
2.7 Operation Confirmation
After writing the program, transfer it to the virtual PLC.
2.7.1 Program Transfer
* Click [Write to PLC] on the remote control or select "Online"
→
"Write to PLC" on the ladder
menu to transfer the program to the virtual PLC.
While transfer is performed, the window shown below is displayed.
When transfer is finished, the message ’Write completed. The simulation will start.’ is
displayed.
2.7.2 Adjustment of Simulation Speed
If you are using a computer with high performance, the operation speed of the machine
simulation may be too high to realize the desired control.
If the message ’part does not stop in front of a sensor’ or the ’input data is not received
properly’ is received, select "Tools"
→
"Options" on the ladder menu and reduce the speed.
The adjusted speed is remembered.
* ’High’ on the scale bar means high speed. Try the operation at medium speed.
If you choose the ’Simple graphic mode’, the background in the 3-D graphic simulation is
omitted. However, troubles may occur in some exercises where the background is necessary.
In the ’Simple graphic mode’, the simulation speed is higher. If a problem occurs, cancel the
’Simple graphic mode’ or reduce the speed of the simulation.
Press [OK] to start the simulation.